Vfo And Memory Scanning; Canning - Yaesu FT DX 3000 Operating Manual

vfo
anD
ou may scan either the
a signal strong enough to open the recei er s uelch.
. et the to the fre uency on hich you ould
like to begin scanning.
otate the [ RF/SQL knob so that the background
.
noise is just silenced.
ress and hold in the microphone [ UP or [ DWN
.
ey for one second to start scanning in the specified
direction on the fre uency.
A :
dvice
If you ould li e to egin scanning on the
fre uency press the [ VFO-B RX Indicator
first then press and hold in the microphone [ UP or
[ DWN key for one second.
. If the scanner halts on an incoming signal the deci-
mal point et een the
the fre uency display ill lin .
A :
dvice
If the incoming signal disappears scanning
resume in a out fi e seconds.
n the and
scanner ill pause on a recei ed signal then ill
step across the signal ery slo ly gi ing you
time to stop the scan if you li e. In these modes
on the the scanner does not stop ho e er.
o cancel scanning press the [ PTT switch.
.
A :
dvice
If you press the microphone PTT switch during
scanning the scanner
pressing the PTT switch during scanning will not
cause transmission.
You may select the manner in which the scanner re-
sumes hile it has paused on a signal using
item 046 MIC SCAN RESUME . he default TIME
sec setting ill cause the scanner to resume scan-
ning after fi e seconds you may change it ho e er
to resume only after the carrier has dropped out.
Page 100
m s
emorY
or the memories of the FT
vFo S
itch
and digits of
ill
ased ata modes the
ill halt at once. o e er
enu

canninG

3000 and the radio ill halt scanning on any fre uency ith
DX
cAnning
FT
DX
[ VFO-B ( RX )] Button
[ RF/SQL ] Knob
3000 O M
peraTing anual