Filter Timers; Reprogramming The Timers; Grease Filters - Miele DA 362-110 Operating And Installation Instructions

A timer monitors the hours of operation.
The indicator for the grease filter will
light after 30 hours of fan operation. The
grease filters must then be cleaned.
After the grease filter has been cleaned
and put back in place, the grease filter
timer must be reset.
^ To do this press the grease filter
button for about 3 seconds.
The indicator will go out.
To change the hours of operation, see

"Reprogramming the timers".

The timer for the charcoal filter is not
preset. Please program this timer, see
"Operation / Reprogramming the
charcoal filter timer". The charcoal filter
indicator will light once the selected
time has elapsed. The
must then be replaced and the
charcoal filter timer must be reset.
^ To do this, press the charcoal filter
button for about 3 seconds.
The indicator will go out.
To check the percentage of time set
already used:
^ Press the joystick to the left to turn
the fan on.
^ Press the grease filter or charcoal
filter button.
The number of flashing indicators show
the percentage of programmed hours
that have been used.
1 indicator = 25 %
2 indicators = 50 %
3 indicators = 75 %
4 indicators = 100 %
This information will remain stored in
memory in the event of a power failure.
13