Shift Lever Override - Chrysler Grand Voyager 2015 Manual

CAUTION! (Continued)
• Tow eyes MUST NOT be used to tow
vehicles off the road or where there are
obstacles.
• In compliance with the above conditions,
towing with a tow eye must take place with
two vehicles (one towing, the other towed)
aligned as much as possible along the
same center line. Damage to your vehicle
may occur if these guidelines are not fol-
lowed.
Front Tow Eye Installation
The front tow eye receptacle is located behind a
door on the front bumper fascia
To install the tow eye, open the door using the
vehicle key or a small screwdriver, and thread
the tow eye into the receptacle.
Insert the flat end of the jack handle through the
tow eye and tighten, refer to "Jacking and Tire
Changing in Section 6 for information". The tow
eye must be fully seated to the attaching
bracket through the lower front fascia. If the tow
eye is not fully seated to the attaching bracket,
the vehicle should not be towed.
Rear Tow Eye Installation
The rear tow eye receptacle is located behind a
door on the rear bumper fascia.
To install the tow eye, open the door using the
vehicle key or a small screwdriver, and thread
the tow eye into the receptacle.
Insert the flat end of the jack handle through the
tow eye and tighten, refer to "Jacking and Tire
Changing in Section 6 for information". The tow
eye must be fully seated to the attaching
bracket through the lower front fascia. If the tow
eye is not fully seated to the attaching bracket,
the vehicle should not be towed.

SHIFT LEVER OVERRIDE

If a malfunction occurs and the shift lever can-
not be moved out of the PARK position, you can
use the following procedure to temporarily
move the shift lever:
1. Turn the engine OFF.
2. Firmly apply the parking brake.
3. Using a small screwdriver or similar tool,
remove the shift lever override access cover
(located near the top right of the shift lever in
the instrument panel).
Shift Lever Override Access Cover
4. Press and maintain firm pressure on the
brake pedal.
5. Insert the screwdriver or similar tool into the
access hole, and push and hold the override
release lever forward.
6. Move the shift lever to the NEUTRAL posi-
tion.
305