Programming - Miele DG 1050 Operating Instructions Manual

The standard settings listed in the chart can be altered. Several settings can be
altered in succession.
Programme
P 1 Demo-mode
P 2 Audible tone volume
P 3 Water hardness
* The factory default settings are shown in bold.
Proceed as follows:
Before you begin, ensure that the
appliance is switched off.
^ Press the function selector gently in
and turn it anti-clockwise slightly.
^ Then release the function selector.
"P1" will appear in the display.
^ Turn the function selector until the
programme you want to alter
appears.
^ Confirm your selection by pressing
the function selector.
Display Setting
the appliance will heat up
OFF
ON the appliance will not heat
up
S1 to S4 The higher the number, the
louder the audible tone
1 Soft
2 Medium
3 Hard
4 Very hard
^ Then turn the function selector until
the setting you want appears.
^ Confirm your selection by pressing
the function selector.
^ After you have altered the settings,
press the function selector until the
display goes out.

Programming

39