Maintenance - Chicago Electric 62204 Owner's Manual

Maintenance instructions
procedures not specifically explained in this manual
must be performed only by a qualified technician.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn Or eLectric SHOcK:
Make sure the power Switch of the plasma cutter is in its "OFF" position and that the plasma cutter is
unplugged from the electrical outlet before performing any inspection, maintenance, or cleaning procedures.
tO preVent SeriOuS inJury FrOM pLaSMa cutter FaiLure:
Do not use damaged equipment. if abnormal noise, vibration, or leaking
air occurs, have the problem corrected before further use.
cleaning and Maintenance
note: These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the air‑operated tool�
BeFOre eacH uSe, disassemble torch,
1�
inspect and replace worn components,
then reassemble torch tightly according
to number 2 on page 10�
2� Daily - air Supply Maintenance:
Every day, maintain the air supply according
to the component manufacturers' instructions�
Drain the dryer regularly.
Performing routine air supply maintenance
will allow the tool to operate more safely
and will also reduce wear on the tool�
3� periODicaLLy, blow the dust from the
cooling vents with compressed air�
Page 12 For technical questions, please call 1-888-866-5797.
4� If the unit repeatedly shuts down
from thermal overload, stop all use�
Have the Plasma Cutter inspected and
repaired by a qualified service technician�
5� Opening the plasma cutter will void the
warranty, and may result in damage to
equipment or possible personal injury.
DO nOt Open tHe HOuSinG.
Any repairs must be completed
by a qualified technician�
6� Store the Plasma Cutter and accessories in a
clean and dry location out of reach of children�
7� WarninG! if the supply cord of this
plasma cutter is damaged, it must be replaced
only by a qualified service technician.
ITEM 62204