Chevrolet 2011 Volt Owner's Manual page 38

2-6 Keys, Doors and Windows
5. Press and hold the POWER
button for two seconds. When
the transmitter is programmed,
the DIC will show that it is ready
to program the next transmitter.
6. Remove the transmitter from the
transmitter slot and press
the transmitter.
To program additional
transmitters, repeat Steps 4
through 6.
When all additional transmitters
are programmed, press and
hold the POWER
for 10 seconds to exit
programming mode.
Starting the Vehicle with a Low
Transmitter Battery
If the transmitter battery is weak,
the DIC may display NO REMOTE
DETECTED when you try to start
the vehicle. The REPLACE
BATTERY IN REMOTE KEY
message may also be displayed at
this time.
To start the vehicle:
1. Open the instrument panel
storage and remove the
rubber mat.
on
button
2. Extend the key blade and place
the blade into the slot.
3. With the vehicle in P (Park) or
N (Neutral), press the brake
pedal and the POWER
on the center stack. See Power
Button on page 9 18 for
additional information.
Replace the transmitter battery as
soon as possible.
Battery Replacement
When replacing the
battery, do not touch any of the
circuitry on the transmitter. Static
from your body could damage the
transmitter.
To replace the battery:
1. Extend the key blade and open
the battery cover on the back of
the unit.
2. Remove the used battery. Avoid
touching the circuit board to
other components.
3. Insert the new battery, positive
side facing down toward
the base.
4. Reassemble the battery cover.
5. Check the operation of the
button
transmitter with the vehicle.