Miele KM 5941 Operating And Installation Instructions page 78

Flush-fitted hobs
Making the worktop cut-out
and building in the hob
Granite and marble worktops
a Worktop
b Hob
c Gap
As the ceramic glass and the
worktop cut-out have a certain
dimensional tolerance, the size of
gap c can vary (min. 1 mm).
78
^ Make the worktop cut-out as shown
in "Building-in dimensions".
^ Feed the hob connection cable down
through the cut-out.
^ Centre the hob b in the cut-out.
^ Connect the hob to the mains.
^ Check that the hob works.
^ Seal the remaining gap c with a
silicone sealant that is heat-resistant
to at least 160 °C.
For granite and marble worktops,
only use silicone sealant that is
especially formulated for granite and
marble, and observe the sealant
manufacturer's instructions.