Hitachi WJ200-001S Quick Reference Manual page 80

Output Function Summary Table – This table shows all functions for the logical outputs
(terminals [11], [12] and [AL]) at a glance. Detailed descriptions of these functions, related
parameters and settings, and example wiring diagrams are in "Using Intelligent Output
Terminals" on page 39.
Option Terminal
Code Symbol

RUN Run Signal

FA1 Frequency Arrival Type
1–Constant Speed

FA2 Frequency Arrival Type
2–Over frequency

OL Overload Advance
Notice Signal 1

OD Output Deviation
for PID Control
 AL Alarm Signal
 FA3 Frequency Arrival Type
3–Set frequency

OTQ Over/under Torque
Signal

UV Undervoltage

TRQ Torque Limited Signal

RNT Run Time Expired

ONT Power ON time Expired

THM Thermal Warning

BRK Brake Release Signal

BER Brake Error Signal
Output Function Summary Table
Function Name
ON When the inverter is in Run Mode
OFF When the inverter is in Stop Mode
ON When output to motor is at the set frequency
OFF When output to motor is OFF, or in any
acceleration or deceleration ramp
ON When output to motor is at or above the set freq,
even if in accel () or decel () ramps
OFF When output to motor is OFF,
or at a level below the set frequency
ON When output current is more than the set
threshold () for the overload signal
OFF When output current is less than the set threshold
for the deviation signal
ON When PID error is more than the set threshold for
the deviation signal
OFF When PID error is less than the set threshold for
the deviation signal
ON When an alarm signal has occurred and has not
been cleared
OFF When no alarm has occurred since the last
cleaning of alarm(s)
ON When output to motor is at the set frequency,
during accel () and decel ().
OFF When output to motor is OFF,
or is not at a level of the set frequency
ON Estimated motor torque exceeds
the specified level
OFF Estimated motor torque is lower than
the specified level
ON Inverter is in Undervoltage
OFF Inverter is not in Undervoltage
ON Torque limit function is executing
OFF Torque limit function is not executing
ON Total running time of the inverter exceeds
the specified value
OFF Total running time of the inverter does not exceed
the specified value
ON Total power ON time of the inverter exceeds
the specified value
OFF Total power ON time of the inverter does not
exceed the specified value
ON Accumulated thermal count exceeds
the  set value
OFF Accumulated thermal count does not exceed the
 set value
ON Output for brake release
OFF No action for brake
ON Brake error has occurred
OFF Brake performance is normal
78
Description