Changing Tires; Jack Operation - Chevrolet 1971 Camaro Owner's Manual

· Changing Tires
Remove hub cap or wheel cover
with fiat end of wheel nut wrench
and loosen wheel nuts slightly. Set
lever on jack to UP position.
Properly position load rest which
engages bumper by moving base of
jack slightly under car and engage
tang of bracket in bumper notch,
then bring jack base back toward
upright position. Check that load
rest is positioned before operating
jack. NOTE: Base of jack column
should be slightly angled in toward
car since it will straighten as car is
raised.
firmly
automatic rralrlSOIlSSlon
VERSE"
lor manual transmission)
Jack Operation
After jack is positioned as noted
above, use wheel nut wrench as
jack handle and raise car until tire
clears ground. Remove wheel nuts
and wheel, install spare and tighten
wheel nuts. Move jack lever to
DOWN and install hub cap or
wheel cover.
block the wheel diagonally opposite .. _.... .,.. __
40
FRONT
POSITION LOAD REST BRACKET
IN BUMPER NOTCH.
REAR
POSITION LOAD REST BRACKET
BETWEEN BUMPER BOLTS.
BUMPER
BOlT