Table of Contents
Advertisement
end vent outlet can be adjusted to
regulate or shut off the desired
amount of conditioned air through
these outlets.
Heater
The windshield defrosting and
defogging system assists in provid-
ing good visibility through desig-
nated areas of the windshield under
most inclement weather conditions.
For immediate operation of the
vehicle, the windshield should be
scraped clear.
AIR-DEF Lever
Pushing the AIR-DEF lever to
the right allows air to pass through
the system. Maximum airflow is
obtained in the AIR position. Ad-
just TEMP (lower) level as re-
quired to give desired degree of
heat. Full right position provides
maximum. heat.
Further movement to the right
of the AIR-DEF lever directs the
airflow through the defroster out-
lets as desired when windshield de-
frosting is needed. At the DEF po-
sition (full right) the entire airflow
is diverted to the defroster outlets.
Vary TEMP lever as required.
Fan
The fan lever has three
(3)
posi-
tions from low at the top to high
at the bottom.
NOTE: Fan will automatically
operate whenever ignition switch
is in the ON position. There is no
OFF position.
Operate system for 30 seconds
before switching to DEF. This will
25
remove humid air from the system
and minimize rapid fogging of the
glass which can occur if humid air
is blown onto a cool windshield.
Heater Operating Tips
• Clear snow and ice from hood
and air inlet in front of wind-
shield to improve heater and de-
froster efficiency and reduce the
probability of fogging on inside
of windshield.
• Clear windshield, rear window,
outside mirrors and all side win-
dows of ice and snow before
driving vehicle.
• Operate blower on "HIGH" for
a few seconds before moving the
Hide quick links:
Advertisement
Table of Contents
