Table of Contents
Advertisement
Available languages
Available languages
immediately.
Should the machine fail despite the rigorous
manufacturing and testing procedures, repair
should be carried out by an authorized IVT customer
services center.
Removing Saw Blade
Please follow the steps:
1.
Pull the plug of power cord out of socket.
2.
Press the spindle lock (5) to prevent the rotation
of the saw blade.
3.
Loosen the hex
bolt (13) using the
hexagon wrench
(15).
(Note:
Please
put the hexagon
wrench into the
storage
(11)
of
the multi purpose
cutter housing when under idle state)
4.
Remove the hex bolt (13) and the outer washer
(14).
5.
Recall (open) the lower guard (8) by using the
lower guard lifting rod (10).
6.
Remove the saw blade (9) carefully.
7.
Wash the multi purpose cutter if necessary. Do
not let any water or other impurities get into the
casing.
Saw Blade Installation
Please follow the steps:
1.
Pull the plug of power cord out of socket.
2.
Clear all the cutting chips in the saw blade.
3.
Recall (open) the lower guard (8) by using the
lower guard lifting rod (10).
4.
Install the saw blade conforming to the following
figure:
Make sure that the arrow in the saw blade is in the
same direction guided by the arrow of the upper
guard (6) of the saw blade.
5.
Install the outer washer (14) properly.
6.
Insert the hex bolt (13).
7.
Press the spindle lock (5) to prevent the rotation
of the saw blade.
8.
Screw up the hex bolt (13) with accessory
hexagon wrench (15), and put it back after
Manual instruction | Multi purpose cutter
operation.
9.
Install the blade in the correct rotation direction,
do not install it in reverse direction, or serious
damage to the blade may occur. Please refer to the
following figures for installation directions:
OK
Correct rotation direction
Washing the multi purpose cutter
1.
Pull the plug of power cord out of socket.
2.
Wipe the multi purpose cutter with a dry and soft
cloth. Do not clean it with wet cloth or detergent, or
the surface coating of the metal cutting machine
will be damaged.
3.
Pay attention to wipe off the grease on the
machine, or the machine will become slippery and
hard to hold.
4.
Remove the saw blade and wipe off dust on it.
Environmental protection
Recycle raw materials instead of disposing
as waste.
Machine, accessories and packaging should be
sorted for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
7
NO
False rotation direction
EN
Advertisement
Table of Contents
