Advertisement
User Interface
To access the advanced features of your G-223, your radio has the following menu
functions:
Mode
Channel
Power
Roger
1~22
Hi/Lo
On/Off
Note : The unit will automatically go to normal mode after 5 seconds of no button activity
during menu setting.
Channel Selection : Your G-223 has 22 channels available. To change channels:
•
With the radio on, press
flashes.
•
Use the
or
buttons to change the channel.
•
Press the PTT button to save the new channel.
http://www.midlandradio.com
Belt Clip :
To install the belt clip:
•
Slide the clip up into the slot on the back of the radio until the latching
mechanism clicks.
To remove the belt clip:
•
Pull the latching tab outward, then
gently slide the belt clip down
toward the bottom of the radio.
http://www.midlandradio.com
until the current channel segment
- 13 -
- 15 -
Power Selection: Your G-223 has two transmit power levels. To select the power
level on channels 1~7 and 15~22:
•
Press
until the "Pr" appears on the display.
•
Press
or
to select between high and low power levels. The
Hi/Lo icon will alternately appear during setting.
•
Press the PTT button to save and exit.
The HI or LO icon will appear on the display depending on your setting.
Note : On channel 8~14 no power level selection is possible
Roger Beep Tone : Whenever you release the PTT button, a "Roger Beep" tone
may be transmitted to let your friends know you are finished talking. To enable the
Roger Beep, press the
button repeatedly until the "rb" appears on the display.
Press the
and
to set the Roger Beep tone on or off. An "on" or "oF"
will appear on the display during setting.
http://www.midlandradio.com
PROBLEM
No Power
- Check battery installation and/or replace batteries
Cannot Receive
- Confirm the radios have the same channel settings.
Messages
- Make sure that you are with in range of the other transceivers.
- Buildings and other obstructions may interfere with your communication.
Radio is not
- Make sure key lock is not on. See "Keypad Lock". (Page 12)
responding to
- Radio might need to be reset. Turn power off then on.
button presses
Display is dim
- Reposition or replace batteries.
- Contacts on the bottom of the radio may require cleaning.
Charger not
- Ensure the outlet the charger is plugged into is functioning properly.
functioning
- Check that the batteries are installed in the radio properly.
If you have a problem which you believe requires service, please call first and speak
with a service technician. Many problems can be remedied over the phone without
returning the unit for service.
http://www.midlandradio.com
- 14 -
SOLUTION
- 16 -
Advertisement
