Ext Speaker Jack; How To Operate Your Transceiver For Cb Use - Midland 77-120ESP Owner's Manual

: When a speaker is connected to this jack the

EXT SPEAKER JACK

internal speaker is by-passed. All received signals will be heard through
the external speaker when it is connected. The speaker connected to the
"EXT" jack should be rated at 8 ohms and 5 watts or more.

HOW TO OPERATE YOUR TRANSCEIVER FOR CB USE

You should become familiar with the controls and complete the preceding
installation instructions before attempting operation of your CB.
1. Adjust the squelch control fully counter-clockwise
2. Rotate the on/off volume control clockwise to turn the unit on. Adjust the
volume for a normal listening level.
3. Select the desired channel by the rotary channel selector. Rotate the squelch
control until the background noise is just quieted. You are now in the receive
mode.
NOTE: If the channel will not change, check that the "CH9 switch is not on. In
this case switch the "CH9" switch off to deactivate this function
4. To transmit press the PTT bar on the side of the microphone. Hold the
microphone 2 to 3 inches from your lips and speak in a normal voice.
5. To receive simply release the PTT bar.
TO OPERATE YOUR TRANSCEIVER FOR WEATHER RECEIVE
1. Follow steps 1 and 2 above.
2. Press the "WX" button.
3. Using the rotary channel selector select the active channel in your area.
www.midlandradio.com
Owner's Manual 77-120 ESP
Page 10 of 13