Hitachi M 6SB Handling Instructions Manual page 5

3. Base angle adjustment
Loosen the right and left wing bolts and adjust the
base angle. (Fig. 7)
The interval of the embossed graduations is 5˚. Lay
a ruler, etc., along the side of the base for use in
chamfering work.
Index mark
Base
HOW TO USE GUIDE
NOTE:
Avoid tilting the base when the guide is used.
1. Trimmer guide
Application:
The guide is handy when used in processing of
materials such as trimming and beveling of plywood.
(1) Fit the trimmer guide on the base with knob bolt
(B).
(2) Loosen knob bolt (B) to move the trimmer guide
up and down.
(3) Loosen knob bolt (C) and turn the stop screw to
move the guide pin. (Fig. 8)
After moving the guide pin, tighten knob bolt (C)
to secure it.
Guide pin
(4) When cutting refer to term "Feeding direction" in
"How to use". (Fig. 9)
Wing bolt
Base ass'y
Fig. 7
Knob bolt (B)
Stopscrew (B)
Knob bolt (C)
Fig. 8
2. Straight guide
Application:
It is handy when used for linear processing work
such as beveling, grooving and the like.
(1) Fit the straight guide with knob bolt (B) on the base
and fix it.
(2) Adjust the length "B" from the bit to the surface
of straight guide by loosening the knob bolt (D) and
rnoving the straight guide as necessary (Fig. 10)
B
(3) When cutting refer to term "Feeding direction" in
"How to use". (Fig. 11)
Fig. 9
Straight guide
Knob bolt (B)
Knob bolt (D)
Fig. 10
Fig. 11
5