Data Plate - Indesit FGIM K Operating Instructions Manual

• Primary air regulation for the oven burner
The burner was designed not to need any
adjustments to the primary air.
• Setting the oven burner to minimum
1. Turn the knob first to the Max setting for about 10
minutes and then to Min.
2. Remove the knob.
5. Make sure the burner does not switch off when
you turn the knob from Max to Min quickly, or
when you open and close the oven door quickly.
! If the appliance is connected to liquid gas, the
regulation screw must be fastened as tightly as
possible.
! Once this procedure is finished, replace the old
rating sticker with one indicating the new type of gas
used. This sticker is available from any of our
Service Centres.
! If the gas pressure is different from the
recommended pressure, a suitable pressure
regulator must be fitted to the inlet pipe in
accordance with current National Regulations.
3. Remove the disk
fastened to the control
panel.
4. Adjust the screw
located outside the
thermostat cock pin
until the flame is small
but steady (the flame
can be seen through the
slots on the oven
bottom).

DATA PLATE

width 43.5 cm
Dimensions height 31 cm
depth 43.5 cm
Volume
58 l
Electrical
see data plate
connections
Gas features
see data plate
This appliance conforms to the
following European Economic
Community directives:
2006/95/EEC dated 12/12/06
(Low Voltage) and subsequent
amendments - 2004/108/EEC
dated 15/12/04 (Electromagnetic
compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent
amendments. 2009/142/EEC
dated 30/11/09 (Gas) and
subsequent amendments.
2002/96/EC and subsequent
amendments.
GB
17