Timing Of Replacing The Lamp - BenQ SX930 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp,
please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector
and in some instances the lamp may explode. Go to
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn
the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after
turning the power back on, please contact your dealer. See
The following Lamp warning displays will remind you to change the lamp.
Install a new lamp for optimal performance. If the projector is
normally run with Economic selected (See
hour" on page 61), you may continue to operate the projector until the
next hour lamp warning appears.
Press MODE/ENTER to dismiss the message.
It is strongly recommended that you replace the lamp at this age. The
lamp is a consumable item. The lamp brightness diminishes with use.
This is normal lamp behavior. You can replace the lamp whenever you
notice that the brightness level has significantly diminished.
Press MODE/ENTER to dismiss the message.
The lamp MUST be replaced before the projector will operate
normally.
Press MODE/ENTER to dismiss the message.
"XXXX" shown in the above messages are numbers that vary depending on different models.
62 Additional information
http://www.BenQ.com
Status
"Getting to know the lamp
for a replacement lamp.
"Indicators" on page 66 for details.
Message
Notice
Replace lamp soon
Lamp hour > XXXX hours
Order a new lamp at www.BenQ.com
Notice
Order a replacement lamp
Lamp hour > XXXX hours
Order a new lamp at www.BenQ.com
Notice
Out of lamp usage time
Replace lamp
then reset the lamp timer
Order a new lamp at www.BenQ.com
Notice
Replace lamp now
Lamp hour > XXXX hours
Order a new lamp at www.BenQ.com
OK
OK
OK
OK