Diagnostic Fault Codes; What If All The Systems On My Scooter Seem To Be Dead?; Basic Troubleshooting - Pride COLT EXECUTIVE Owner's Manual

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FAULT CODES

The diagnostic fault codes for your scooter are designed to
help you perform basic troubleshooting quickly and easily.
A diagnostic fault code and error message will be displayed
(see figure 22) in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the fault code
condition is resolved and the scooter has been turned off,
then turned back on.
FAULT CONDITION
CODE
Batteries need charging
1
Low voltage, batteries need
2
charge immediately
Over Voltage
3
Over Current
4
Park brake fault
5
Throttle control lever not centred
6
at start up
Throttle control lever broken or
7
faulted
Motor fault
8
Other fault
9

What if all the systems on my scooter seem to be dead?

Make certain that the key is in the "on" position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. "Your Scooter."
Make certain that both battery harnesses and the front-to-rear harness are firmly connected.
Be sure the power down timer feature has not been activated. See V. "Operation."
34
SOLUTION
Charge batteries as soon as possible.
Charge batteries as soon as possible.
Unplug charger and/or turn scooter off, then back on.
Turn scooter off for a few minutes, then turn scooter
back on.
Remove the key from the key switch, then push the
manual freewheel lever to the drive (rearward)
position and restart your scooter.
Return the throttle control lever to centre position,
turn scooter off, then back on.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
www.pridemobility.com
FAULT CODE
Figure 22. Fault Code Display
ERROR
MESSAGE
ERROR
MESSAGE
N/A
Lo BAT
HI BAT
HI CUR
BRAKE
T POT
T POT
MOTOR
OTHER
Colt Executive