Table of Contents
Advertisement
STARTING AND DRIVING
D Before you lower the vehicle height with the height
select switch, check under the vehicle to make sure
that nothing to damage the vehicle or no one to be
injured is there and the underbody of the vehicle
does not touch the ground.
D After unloading, the height of a vehicle equipped with
the active height control suspension becomes
slightly higher than the normal vehicle height. Take
sufficient care where the overhead height is
restricted.
The vehicle height cannot be raised if the vehicle load
exceeds the following limits:
D Up to 4 occupants* plus about 300 kg (661 lb.) in the normal
mode
D Up to 4 occupants* plus about 170 kg (375 lb.) in the high
mode
*About 68 kg (150 lb.) for a person
If the above load capacity is exceeded, the desired vehicle
height may not be obtained even if the height select switch is
pushed. (If the vehicle height cannot be raised in the normal
mode and the height control indicator indicates "LO", this is
because the vehicle is loaded too heavily. Under these
conditions, drive your vehicle with due care.)
If the vehicle height cannot be raised even after unloading,
push the height select switch on the "B" side and then on the
"Y" side. If this does not work, turn off the ignition once and
then turn on. Operate the select switch again.
282
If the vehicle height is adjusted on the slope, or with the
selector lever in a position other than "P" or "N" while the
vehicle is stopped, you may hear a sound caused by the
expansion and contraction of the propeller shaft.
D Selecting the high mode:
Push the height select switch on the "Y" side when the vehicle
speed is under about 30 km/h (19 mph).
To change the normal mode to high, push the switch once.
To change the low mode to high, push the switch twice. It
takes about 30 seconds until the low mode changes to the high
mode.
D Selecting the normal mode:
To change the high mode to normal, push the height select
switch on the "B" side once.
To change the low mode to normal, push the height select
switch on the "Y" side once.
D Selecting the low mode:
Push the height select switch on the "B" side while the vehicle
is stopped.
To change the high mode to low, push the switch twice.
To change the normal mode to low, push the switch once.
Advertisement
Table of Contents
