Table of Contents
Advertisement
AIR CONDITIONING
SETTING OPERATION
manual control
When one of the manual control buttons is depressed
while operating in automatic mode, the mode relevant to
the depressed button is set. Other conditions continue to
be adjusted automatically.
If manual air flow selection is desired
20X021a
The outlets from which air is delivered can be selected
manually by pressing the button. The function of each mode
is as follows:
1
Panel Air flows mainly from the instrument panel vents.
2
Bi level
Air flows from both the floor vents and the
instrument panel vents.
3
Floor
Air flows mainly from the floor vents.
It is recommended that you close the lower vent. For details
about this, see page 212.
206
4
Floor/Windshield
Air flows mainly from the floor vents
and windshield vents.
It is recommended that you close the lower vent. For details
about this, see page 212.
If quick heating or cooling is desired
Turn the "TEMP" knob until "MAX. HOT" or "MAX. COLD"
appears on the display.
If manual fan speed control is desired
21x600
" 1 Fan speed at low
2 Fan speed at high
The fan speed can be set to your desired speed by pushing the
appropriate side of fan speed control button. The higher the
fan speed is, the more air is delivered. Pushing the "OFF"
button turns off the fan.
To remove exterior windshield frost, use the high speed
setting.
Advertisement
Table of Contents
