18
e. Attach the power supply line cord to a power supply.
CAUTION
5. Verify the behavior of the Access Point's LEDs. For more information, see
6. Align the bottom of the ceiling T-bar with the back of the Access Point.
7. Orient the Access Point chassis by its length and the length of the ceiling T-bar.
8. Rotate the Access Point chassis 45 degrees clockwise.
9. Push the back of the Access Point chassis on to the bottom of the ceiling T-bar.
10. Rotate the Access Point chassis 45 degrees counter-clockwise. The clips click as they fasten to the T-bar.
11. The Access Point is ready to configure. For information on basic Access Point device configuration, see
Basic Access Point Configuration
NOTE
Do not actually connect to the power source until the cabling portion
of the installation is complete.
.
If the Access Point is utilizing remote management antennas, a wire
cover can be used to provide a clean finished look to the installation.
AP7131 Series Access Point
Three Radio AP7131N LEDs
.