The Timer; Cleaning Lock - Bosch NIT8665UC Use And Care Manual

Recommendations and
warnings

The timer

It is programmed as
follows
Once the time has elapsed
Correcting the time
Switching the timer off
Recommendations and
warnings

Cleaning lock

Note
24
To program a cooking time of less than 10 minutes, always press 0 before selecting
the required value.
Any cooking time can be programmed up to 99 minutes.
After a loss in power, the time programming function will no longer be activated.
This can be used to time periods up to 99 minutes. It is independent of the other
settings.
1. Press the Timer symbol. 00 appears in the time programming function display.
The ___, min and U indicators light up.
2. Set the required time using symbols 1 to 9.
After a few seconds, the ___ indicator goes out and the programmed time starts to
count down.
A beep sounds. 00 and U also appear in the time program function display.
Press the Timer symbol. The indicators go out and the warning beep stops.
Press the Timer symbol.
The ___ and U indicators light up.
Change the time using symbols 1 to 9.
Press the Timer symbol.
The ___ and U indicators light up.
Then press the 0 symbol until 00 appears on the time program function display.
The U indicator goes out.
If the set time is not displayed, press the
Timer symbol several times until the U indicator lights up on the time program
function display.
To program a cooking time of less than 10 minutes, always press 0 before selecting
the required value.
The timer will be deactivated after a power outage.
The element automatic OFF function and the timer function can both be operated
simultaneously.
Cleaning the control panel while the cooktop is on may change the settings.
To avoid this, the cooktop has a control panel pause function.
Press the Clean lock symbol until the > indicator appears. The control panel is
locked for approximately 35 seconds.
The surface of the control panel can now be cleaned without risk of changing the
settings.
After the time has elapsed, a warning beep will sound and the function is
deactivated. The control panel lock has been deactivated.
This block does not affect the Clean lock symbol or the main switch. The control
panel pause function can be deactivated and the cooktop can be switched off at
any time.