Manual Programming - Steren RM-310 Instruction Manual

2. PROGRAMMING
Do not exceed more than 15 seconds between each step, since the remote control will exit the
programming mode and you will have to start again.

2.1 Manual programming

1. In the section "Programming code" locate the code corresponding to the component to be controlled.
2. Manually turn on the component (TV, AUX, etc.).
SET
INPUT
PC TV AUX
4. Press and hold the SET button until the button (TV, AUX, etc..) is activated.
5. Enter the programming code corresponding to the component's brand. To verify that the code is correct,
the indicator flashes three times and turns off.
Otherwise, it will flash and remain on, indicating an error.
Press▲ / ▼ to perform a test. If the device responds, press SET
and operate the control in a normal way.
Where the functions to operate incorrectly or that the code
is unsupported, program the control with other code that
corresponds to your equipment.
Recommendations:
-If no list code work properly (or the brand of your device is not on the list), use the semi-manual
programming method.
4
3. Select the button of the computer that you want to program.
STB