Installation Of The Ms700 Series Stand - Metrologic MS700i Installation And User Manual

Installation of the MS700 Series Stand

The following are components used to build the MS700 Series stand
(MLPN: 45483):
Figure 2
1 Shoe Mount
2 Stand Cover
3 Stand Base
1. Use the 2½ inch x 2½ inch stand base to mark the position for pilot
holes.
2. Use the four wood screws to secure the base to the work surface.
3. Position the stand cover on top of the stand base.
4. Screw the flexible shaft to the stand base.
5. Place the internal lock washer on top of the flexible shaft and then
screw the shoe to the shaft with the machine screw.
12
4 Four Wood Screws
5 One Machine (¼-20) Screw
6 Internal Lock Washer
7 Flexible Shaft