Table of Contents
Advertisement
I
NSTALLATION
C
I
(I
ABLE
NSTALLATION
IBM 46
XX
The following steps describe how to properly install the cables for an IBM 46xx scanner application. The scanner must then
be configured to match the host's IBM 46xx parameters. Cable installation alone does not guarantee that the scanner will
communicate properly with the host system.
Configuration bar codes are located in the MetroSelect Configuration Guide (
MS2xxx Stratos Series Configuration Addendum (
1.
Turn off the host system.
2.
Plug the 10-pin RJ45 end of the IBM interface cable (
46xx, on the bottom of the scanner. Refer to Figure on page 21.
3.
Connect the other end of the IBM cable to communication port 9 on the host device.
Before continuing verify that the IBM cable is connected to the appropriate interface socket on the scanner. An
incorrect cable connection can cause communication problems or potential damage to the scanner and/or terminal.
Manufacturers Note: Plugging the scanner into the serial port of the host device does not guarantee that scanned
information will appear at the host device. A software driver and correct configuration settings are also required for
proper communication to occur.
4.
Plug the external power supply (
scanner.
Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet. The outlet
should be located near the equipment and be easily accessible.
Metrologic recommends using a switched AC outlet. The switch should be located on the operator's side of the
checkout counter in close proximity to the scanner to facilitate calibration and service of the unit.
5.
Connect AC power to the transformer. If the AC outlet is equipped with an on/off switch, turn the power on.
6.
Turn on the host system.
7.
Configure the scanner to match the host system's IBM 46xx parameters.
Refer to the MS2xxx Stratos Series Configuration Addendum (
Bar Codes: IBM 3
Additional general configuration bar codes can be found in the MetroSelect Configuration Guide
(
00-02407x).
MLPN
20
S
)
NTERFACE
PECIFIC
46-002xx) into the 3-pin Molex socket labeled, DC Power In, on the bottom of the
MLPN
rd
Generation Communication Defaults and IBM 3
00-02034x).
MLPN
57-57212x-N-3) into the 10-pin socket labeled Scanner Host
MLPN
00-02034x) under Scanner Configuration
MLPN
rd
Generation Protocols.
00-02407x) and the
MLPN
Advertisement
Table of Contents
