Aligning The Running Belt (Fig. G) - Tunturi pure run 10.1 User Manual

– If you feel lubrication or your
fingertips are shiny, there is suf-
ficient lubrication on the running
belt.
– If you do not feel lubrication or
your fingertips are dusty or rough,
use a large spoon to apply a
silicon lubricant (15-20 ml) in the
middle of the running deck under
the running belt and let the equip-
ment operate at 5 km/h for at
least 5 minutes.
– After lubrication, do not fold the
equipment before having done
a workout for 20 minutes with a
speed of at least 5 km/h. The lu-
bricant will be spread evenly over
the running belt.

Aligning the running belt (fig. G)

The running belt must run in the center
of the rollers. If the running belt is
pushed to one side, the running belt
must be aligned using the adjustment
bolts at the rear of the equipment.
CAuTION
– Make sure that the running belt is
aligned correctly to prevent damage
to the edges of the running belt.
1. Set the mains power switch to the on
position.
2. Set the speed to 5 km/h.
3. If the running belt runs in the center
of the rollers, the running belt is
aligned correctly.
4. If the running belt drifts to the left,
turn the left adjustment bolt 1/4 turn
clockwise and the right adjustment
bolt 1/4 turn counterclockwise.
5. If the running belt drifts to the right,
turn the right adjustment bolt 1/4 turn
clockwise and the left adjustment bolt
1/4 turn counterclockwise.
6. Repeat the last 2 steps until the
running belt is aligned to the centre.
O w n e r ' s m a n u a l
Adjusting the running belt tension
The running belt tension must be
adjusted when it starts to slip on the
rollers. The running belt tension must be
adjusted using the adjustment bolts at
the rear of the equipment.
CAuTION
– Make sure that the running belt is
aligned correctly to prevent damage
to the edges of the running belt.
1. Set the mains power switch to the on
position.
2. Set the speed to 5 km/h.
3. Turn both adjustment bolts 1/4 turn
clockwise an equal amount of times.
4. Slow down the running belt by hold-
ing onto the side handlebars and
braking as you walk.
5. If the running belt slips, turn both ad-
justment bolts 1/4 turn clockwise and
repeat the test.
6. If the belt keeps slipping after several
tests, contact the dealer.
Defects and malfunctions
Despite continuous quality control,
defects and malfunctions caused by
individual parts can occur in the equip-
ment. In most cases, it will be sufficient
to replace the defective part.
1. If the equipment does not function
properly, immediately contact the
dealer.
2. Provide the model number and the
serial number of the equipment to
the dealer. State the nature of the
problem, conditions of use and
purchase date.
error codes
If the display shows an error code
(marked with "E" + number), restart
the equipment and check whether the
display still shows the error code. If
the display still shows the error code,
immediately contact the dealer.
GB
•
P u r e r u N 1 0 . 1
15