Preparation - Mitsubishi Electric PK10 User Manual

Preparation

Preparation for projection
1. Attach the provided AC adapter to the projector.
2. Plug the AC adapter in the wall outlet.
The POWER indicator lights red when using the
AC adapter.
Warning:
Do not look into the lens directly when the projector is
on.
Use 100-240 V AC 50/60 Hz to prevent fire or electric
shock.
Do not place any objects on the AC adapter and power
cord or do not place the projector near heat sources
to prevent damage to the power cord. If either the AC
adapter or power cord should be damaged, contact
your dealer for replacement because it may cause
fire or electric shock.
Do not modify or alter the AC adapter. If the AC adapter
is modified or altered, it may cause fire or electric
shock.
EN-18
Downloaded From projector-manual.com Mitsubishi Manuals
Caution:
Plug in the power cord firmly. When unplugging, hold
and pull the power plug, not the power cord.
Do not plug in or out the power cord with your hand
wet. It may cause electric shock.
Important:
Install the screen on a flat wall at 90 degrees to the floor.
Images may not be projected in a shape of a regular
rectangle or with its aspect ratio 4:3, depending on the
installation conditions of the projector and the screen.
To correct vertical keystone distortion:
On the optional remote control: press the KEYSTONE
buttons.
On the control panel: adjust KEYSTONE in the
INSTALLATION menu.
In the following cases:
Press the KEYSTONE . Press the KEYSTONE .