Controls - GE AEZ18 Owner's Manual

About the controls on the air conditioner.
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
0
Light indicates the unit is in the
temperature or delay time Set mode.
Dght indicates the
delay timer Jsset.
•Auto @O
[] High [] Cool
[] Med [] Fan Only
[] Low [] Energy Saver
0 0
NOTE: The display always shows the room temperature except
when setting the Set temperature or the Delay timer.
Air Conditioner Controls
Delay
---_ timer
Increase
J----_ Auto Fan
on
_j_.OFon speed
Increase
_ nit power
on/off
Remote Control
4
Controls
Power Pad
Turns air conditioner on and off. When
turned on, the display will show the room
temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
Temp Increase A/Decrease T Pads
Use to set temperature when in Cool or
Energy Saver mode. The Set light will turn on
while setting.
Delay Timer Increase A (+)/Decrease
(-) Pads
Eachtouch of the Increase A / Decrease T
pads on the unit or the Increase + / Decrease
- pads on the remote control will set the delay
time when using the Delay 1-24hr timer. The
Set light will turn on while setting.
Fan Speed
Pads
Useto set the fan speed to Law, heed,High
or Auto on the unit. NOTE:On the remote
control, use the fan speed Increase + /
Decrease - pads to set the fan speeds to Low,
heedor High. Usethe Auto pad to turn Auto
fan on.
Mode Pad
Useto set the air conditioner to Coo/,Energy
Saver or Fan Only mode.
Delay Pads/Delay 1-24hr Pad
Delay ON--When the air conditioner is off, it can
be set to automatically come on in I to 24 hours
at its previous mode and fan settings.
Delay OFF--When the air conditioner is on,
it can be set to automatically turn off in I to
24 hours.
How to set:
Pressthe Delay 1-24hr pad on the unit or the
Delaypad on the remote control. Each touch
of the Increase A / DecreaseT pads on the
unit or the Increase + / Decrease - pads on
the remote control will set the timer in 1-hour
intervals. The Set light will turn on while setting.
To review the remaining time on the Delay
.1.-24hrtimer, press the Delay .1.-24hrpad on
the unit or the Delaypad on the remote control.
Usethe Increase A / Decrease _' pads on the
unit or the Increase + / Decrease - pads on the
remote control to set a new time if desired.
To cancel the timer, press the Delay 1-24hr pad
until the light on the Delay 1-24hr pad goes off.
Reset Filter
LEDwill turn on when fan has accumulated 250
hours of run time as a reminder to clean filter.
PressReset Filter to turn off the LEDand reset
the accumulated run time.
Note: The default temperature reading on the display is degree Fahrenheit (°F). To change the display to
degree Celcius (°C),press the Temp Increase A and Temp Decrease T buttons together and hold for 3
seconds. Repeat the process to change back to degree Fahrenheit (°F)