Dell S6000–ON Configuration Manual page 1012

• Create a virtual router for that interface with a VRID.
INTERFACE mode
vrrp-group vrid
The VRID range is from 1 to 255.
NOTE: The interface must already have a primary IP address defined and be enabled, as shown
in the second example.
• Delete a VRRP group.
INTERFACE mode
no vrrp-group vrid
Examples of Configuring and Verifying VRRP
The following examples how to configure VRRP.
Dell(conf)#interface tengigabitethernet 1/1/1
Dell(conf-if-te-1/1/1)#vrrp-group 111
Dell(conf-if-te-1/1/1-vrid-111)#
The following examples how to verify the VRRP configuration.
Dell(conf-if-te-1/1/1)#show conf
!
interface TenGigabitEthernet 1/1/1
ip address 10.10.10.1/24
!
vrrp-group 111
no shutdown
Configuring the VRRP Version for an IPv4 Group
For IPv4, you can configure a VRRP group to use one of the following VRRP versions:
• VRRPv2 as defined in RFC 3768, Virtual Router Redundancy Protocol (VRRP)
• VRRPv3 as defined in RFC 5798, Virtual Router Redundancy Protocol (VRRP) Version 3 for IPv4 and
IPv6
You can also migrate a IPv4 group from VRRPv2 to VRRP3.
To configure the VRRP version for IPv4, use the version command in INTERFACE mode.
Example: Configuring VRRP to Use Version 3
The following example configures the IPv4 VRRP 100 group to use VRRP protocol version 3.
Dell(conf-if-te-1/1/1)# vrrp-group 100
Dell(conf-if-te-1/1/1-vrid-100)#version ?
2 VRRPv2
3 VRRPv3
both Interoperable, send VRRPv3 receive both
Dell(conf-if-te-1/1/1-vrid-100)#version 3
You can use the version both command in INTERFACE mode to migrate from VRRPv2 to VRRPv3. When
you set the VRRP version to both, the switch sends only VRRPv3 advertisements but can receive VRRPv2
or VRRPv3 packets.
1012
Virtual Router Redundancy Protocol (VRRP)