High/Low Beam Change (Dimmer); Headlight Flasher; Daytime Running Light System - Subaru 2007 Impreza-WRX Owner's Manual

& High/low beam change (dim-
mer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light " " on the instru-
ment panel is also on.
To switch back to low beam, pull the lever
back to the detent position.
& Headlight flasher
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the light switch is in the
"OFF" position.
When the headlights are on high beam,
the high beam indicator light "
instrument panel also comes on.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
Instruments and controls
& Daytime running light system
! WRX-STI
The low beam headlights, side marker
lights, tail lights, parking lights, and license
plate lights will automatically come on
when the engine has started, under the
following conditions:
. The parking brake is fully released.
. The light switch is in the "OFF" or "
position.
. The automatic transmission selector
lever is set at other than the "P" position.
The light switch must always be
turned to the "
is dark outside.
! Except WRX-STI
" on the
The low beam headlights will automati-
cally come on at reduced brightness when
the engine has started, under the following
conditions:
. The parking brake is fully released.
. The light switch is in the "OFF" or "
position.
. The automatic transmission selector
lever is set at other than the "P" position.
3-23
"
WARNING
" position when it
"
– CONTINUED –