Preparation For Use - Echo CS-800P Operator's Manual

Chain brake lever
(Front hand guard)
Clutch cover
Two nuts
Two bolts 6 × 20 and washers
Clutch
Pin
Adjuster hole
Brake band
Unlock chain brake
CS-800P

PREPARATION FOR USE

Two bolts 6 × 14
Spiked bumper
Nuts
Spiked bumper
Guide bar studs
Guide bar
Nuts
Chain
Hole
Clutch cover
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
NOTICE
Move the chain brake lever (Front hand guard)
fully rearward to remove or install the clutch
cover to chain saw.
1. Remove spark plug lead. (See page 26)
2. Remove two clutch cover nuts and remove
clutch cover.
3. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
4. For initial setup, install spiked bumpers - one on
front of machine with two 6 × 14 mm bolts and
one on clutch cover with two 6 × 20 mm bolts,
washers and nuts each.
5. Mount guide bar on studs and slide toward
clutch to make saw chain installation easier.
Install chain with cutters on top of guide bar
facing forward.
6. Slide bar forward and ensure tensioner pin fits
into lower adjustment hole.
7. Unlock the chain brake, and install the clutch
cover over the guide bar studs. Ensure brake
band is positioned around clutch drum and hole
at rear of clutch cover fits pin on engine cover.
Tighten clutch cover nuts finger tight.
8. Turn saw over and check brake band for correct
position on clutch drum. If brake band is not in
place around drum, remove cover, make sure
brake is unlocked, and reinstall. Tighten clutch
cover nuts finger tight.
Improper clutch cover assembly can result
in serious injury, and will cause severe saw
damage if unit is started. Never start or
operate saw if brake band is not in place
on clutch drum. Always check chain brake
operation after replacing cover. Do not use
saw if chain brake does not function properly.
10
WARNING
WARNING