Table of Contents
Advertisement
Radio operation
Selecting the waveband
FM - with FM-T button C.
AM - with AM button A.
Selecting a station
... using Scan (on/off) 1
If you wish to tune to another station
press the Scan button 1.
Starting from the currently received radio
programme, the set automatically tunes to
the next station frequencies in upward di-
rection and plays them for 8 seconds. During
search tuning, the display D a shows "SCAN"
and while the radio programmes are previe-
wed the station frequency flashes in the
display D a.
To select a scanned station
press the Scan button 1 once again.
The Scan function is switched off.
If you do not select a station, the set plays
again the radio programme which was tuned
in before Scan was activated.
... using the search tuning rocker switch
Start automatic search tuning
by pressing the rocker switch
Start search tuning as often as required
until the radio programme of your
choice is tuned in.
22
If you hold the rocker switch depressed,
search tuning continuous quickly.
... using preset buttons and memory
banks
This function can be used only, if station
frequencies have been stored on the preset
buttons as described in chapter "Storing a
station".
To recall FM stations, press the FM•T
button C until the desired memory
bank I, II, III or T is shown in the display
D c.
Then press shortly the desired preset
button.
... using Preset Scan (PS) ?
This function allows you to scan and introdu-
ce the stored radio programmes of the se-
lected waveband (in FM mode on all memory
banks I, II, III and T).
This function can be used only, if station
frequencies have been stored on the preset
buttons as described in chapter "Storing a
station".
Press PS shortly. The set introduces
F.
/
the next preset programme.
The programme of this station is played for a
short time, then the next preset programme is
scanned, etc. If no frequency is stored on a
preset button, this preset is skipped.
Preset Scan can be used on all wavebands.
As soon as you have found the programme of
your choice
press PS once again. Preset Scan is
switched off.
Storing a station
In the FM mode, six stations can be momori-
zed on each of the three memory banks. Use
the FM•T button C to select the memory
bank. Another six stations can be stored on
the AM range. Beyond that, the six strongest
FM stations can be stored automatically on
the Travelstore bank.
When required, the stored stations can be
recalled by pressing a button.
... using automatic search tuning
If you want to memorize a station frequency
follow the steps below:
For FM stations, select the memory
bank by pressing the FM•T button C
as often as required. The display D c
shows I, II, III or T.
To store a station frequency,
press one of the preset buttons @ until
the radio mute is off and the set resu-
mes reproduction of that programme
(after about 2 seconds) to indicate that
the station is stored.
Advertisement
Table of Contents
