Epson Stylus Photo R220 Service Manual page 56

EPSON Stylus Photo R220/R230
When reinstalling the Porous Pad, Paper Guide, Front/
the Porous Pad, Paper Guide, Front, Support
Fold perpendicularly the left and right sides of the Porous
Pad, Paper Guide, Front, Support at the marks and install it
to the Paper Guide, Front. Make sure to put the slit onto the
rib on the side of the Paper Guide, Front and keep the pad
flat on the guide.
Apply Three Bond 1401 to the six points shown in
Figure2-14.
Install the Porous Pad, Paper Guide, Front in piles. Put it
under the rib and check if it is securely fit. Adjust the
clearance between the Porous Pad, Paper Guide, Front and
the Paper Guide, Front to approximately 0.5-1.0mm.
When reinstalling the Porous Pad, Paper Guide, Front, Support,
Attach the Porous Pad, Paper Guide, Front, Support by
inserting its feet into the holes of the Paper Guide, Front
shown in Figure2-13, then put the three portion of the pad
support under the rib and check if it is securely fit.
Be careful not to damage the Porous Pad, Paper Guide, Front,
C A U T I O N
Support.
Do not apply too much adhesive. Do not contaminate the Porous
Pad, Paper Guide, Front, Support with the adhesive.
Install the Porous Pad, Paper Guide, Front immediately after
applying the adhesive.
Make sure that the three Porous Pads are fitting on the guide
surface securely.
DISASSEMBLY / ASSEMBLY
Å@
Disassembly
Revision A
56