Buell 2003XB9S Service Manual page 479

HOME
INSTALLATION
NOTE
If clutch pack replacement was the only service work per-
formed, start with Step 5.
8816
Figure 6-35. Adjusting Screw Assembly Aligning Tabs
1. See Figure 6-35. Remove adjusting screw assembly in
order to install mainshaft nut and washer.
2. Install the engine sprocket, clutch assembly and primary
chain as a unit into primary chaincase.
NOTE
Prior to installing engine sprocket nut and the clutch hub nut,
the threads on the sprocket shaft, sprocket nut, mainshaft
and clutch hub nut must be thoroughly cleaned to remove any
oil that might contaminate and interfere with the locking
agent.
6-20 2003 Buell XB9S: Drive/Transmission
8810
1
1. Torque wrench
2. Engine sprocket
3. Sprocket locking link (Part No. HD-38362)
Figure 6-36. Sprocket Locking Link
3. See Figure 6-36. Install the engine sprocket nut.
a. Install SPROCKET LOCKING LINK (Part No. HD-
38362).
b. Apply two or three drops of LOCTITE 262 (red) onto
threads of sprocket shaft.
c. Install engine sprocket nut. Tighten to 190-210 ft-lbs
(257.6-284.7 Nm).
3
2