Kenmore 110.80754 Use And Care Manual page 12

3=
3-wire connection: Power supply cord
4=
Move the green painted screw from the internal to the
external ground location. Connect ground wire (green or bare)
of power supply cable to external ground conductor screw.
Tighten screw.
B
©
G F E D
A. Neutral wire (white or center wire)
B. Center terminal block screw
C. Neutral ground wire
D. External ground conductor screw
E. Ground wire (green or bare) of power supply cable
E Internal ground conductor location
G. 3/4" (19 mm) UL fisted, strain relief
Place the hooked ends of the other power supply cable wires
under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
1=
2.
A ...... i
C
D E
G F
A. 3-wire receptacle (NEMA type 10-30R)
B. 3-wire plug
C. Neutral prong
D. Spade terminals with up turned ends
E. 3/4" (19 mm) UL fisted strain relief
E Ring terminals
G. Neutral (white or center wire)
Loosen or remove center terminal block screw.
Connect neutral wire (white or center wire) of power supply
cord to the center, terminal screw of the terminal block.
Tighten screw.
B
/
5. Tighten strain relief screw.
6. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
7. You have completed your electrical connection. Now go to
"Venting Requirements."
A. Neutral wire (white or center wire)
B. Center terminal block screw
C. Neutral ground wire
D. Internal ground conductor screw
E. 3/4" (19 mm) UL listed, strain relief
3. Connect the other wires to outer terminal block screws.
Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
6. You have completed your electrical connection. Now go to
"Venting Requirements."
12