Advertisement
Operation
PUSH BAR
Press the push bar to open/close the door.
GARAGE DOOR OPENER LIGHTS
Press the LIGHT button to turn the garage door
opener lights on or off. When the lights are
turned on they will stay on until the LIGHT
button is pressed again, or until the garage
door opener is activated. Once the garage door
opener is activated the lights will turn off after
the specified period of time (the factory setting
is 4-1/2 minutes). The LIGHT button will not
control the lights when the door is in motion.
MOTION SENSOR
This feature will automatically turn on the
garage door opener lights when motion is
sensed. The lights will come on for the set
period of time, then shut off.
LIGHT FEATURE
The lights will turn on when someone enters
through the open garage door and the safety
reversing sensor infrared beam is broken.
If using the garage door opener light as a work
light, turn the light on using the light button on
the wall control or the light will turn off if you
are beyond the range of the sensor.
Program
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
1
Press the LEARN button on the door
control to enter Programming Mode.
The command LED will flash once.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
Repeat the steps above for programming additional remote controls or keyless entry devices.
TIMER-TO-CLOSE (TTC) FOR MODEL
41A7327-1 ONLY
DO NOT enable TTC if operating a one-piece
door. TTC is to be used ONLY with sectional
doors.
The TTC can be turned on or off and the time
interval can be adjusted to 1, 5, and 10 minute
intervals. Once the TTC has been set and the
door is open, the selected close interval will
blink and begin to count down to close the
door. The garage door opener will beep and the
lights will flash before closing the door.
To temporarily suspend the TTC feature press
and release the HOLD OPEN button (the HOLD
OPEN button will light solid). Press the HOLD
OPEN button again to resume normal TTC
operation.
The TTC feature will deactivate if the garage
door encounters two sequential obstructions;
or the safety reversing sensors are incorrectly
installed. The garage door will reverse open and
WILL NOT close until the obstructions are
removed or the safety reversing sensors are
correctly installed. When the obstruction has
been cleared or the safety reversing sensors
have been aligned, the door will close when the
garage door opener is activated.
2
Press the LEARN button again, the
LED will flash once.
The command LED will flash once again.
Push Bar
1 Minute
TTC LED
5 Minute
TTC LED
10 Minute
TTC LED
3a
Press the button on the remote
control that you wish to operate
your garage door.
3
HOLD OPEN Button for the
Timer-To-Close (TTC)
LIGHT Button
Motion Sensor
3b
Enter a 4-digit personal
OR
identification number (PIN) of your
choice on the keyless entry keypad.
Then press the ENTER button.
?
?
?
?
PIN
Advertisement
