Advertisement
Installation
Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small
children cannot reach, and away from the moving parts of the door. For gang box installations it is
not necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box.
NOTE: Pre-wiring means that your garage already has wires installed for the door control.
WIRE THE DOOR CONTROL
1
Unplug the garage door opener to
ensure the door control cannot be
activated during wiring.
Strip 7/16" (11 mm) of insulation from
2
one end of the wire and separate the
wires.
7/16" (11 mm)
Connect the wire to both screws on the
3
back of the door control. The wires can
be connected to either screw.
PRE-WIRED INSTALLATIONS: Choose any two
wires to connect, but make note of which wires
are used.
MOUNT THE DOOR CONTROL
1
Mark the location of the bottom
mounting hole and drill a 5/32" (4 mm)
hole.
Install the bottom screw, allowing
2
1/8" (3 mm) to protrude from the wall
Position the bottom hole of the door
3
control over the screw and slide down
into place.
- Wall -
3
1
2
DRYWALL
6ABx1-1/4"
4
Lift the push bar up and mark the top
hole.
Remove the door control from the wall
5
and drill a 5/32" (4 mm) hole for the
top screw.
Position the bottom hole of the door
6
control over the screw and slide down
into place. Attach the top screw.
4
6
5
2
HARDWARE
GANG BOX
6-32x1"
Drywall Anchors
WIRE TO GARAGE DOOR OPENER
1
Strip 7/16" (11 mm) of insulation from
the end of the wire near the garage door
opener.
7/16" (11 mm)
Connect the wire to the red and white
2
terminals on the garage door opener.
The wires can be connected to either
terminal.
To insert or release
wire, push in tab with
screwdriver tip.
PRE-WIRED INSTALLATIONS: Connect the same
wires to the garage door opener that were
previously connected to the door control.
Reconnect power to the garage door
3
opener. The command LED behind the
push bar on the door control will blink
if installed correctly. To synchronize
the garage door opener and the door
control, press the push bar up to
3 times. Press until the garage door
opener activates.
Advertisement
