Advertisement
Available languages
Available languages
User Responsibility
This tool will perform in conformity with the description contained in the instructions provided. This tool must be
checked periodically. Defective equipment (including service leads) should not be used. Parts that are broken,
missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or re-
placement become necessary, it is recommended that such repairs are carried out by qualified persons approved
by Elektra Beckum or its representatives.
This tool or any of its parts should not be altered or changed from standard specifications. The user of this tool
shall have the sole responsibility for any malfunction which results from improper use or unauthorized modification
from standard specifications, faulty maintenance, damage or improper repair by anyone other than qualified
persons approved by Elektra Beckum or its representatives.
Safety Precautions
Always wear appropriate apparel
Always disconnect from compressed air supply before servicing
Do not exceed the stated operating pressure
The work place sound power level can exceed 85 dBA. In this case noise control measures for the operator
are required!
Preparing for Operation
Ensure compressed air is dry and air lines do not contain condensate. Treat rusted or frozen nuts/screws with
penetrating oil before attempting to loosen with this tool.
Air Supply
The operating pressure for this air tool should not exceed 6 bar/87 psi. A higher operating pressure, as well as
soiled air shorten the life of the air tool and may cause dangerous situations. Condensate (condensed water) in
the air lines damages an air tool. Drain condensate from pressure vessel daily. Clean filter or screen in air inlet
of the air tool at least once a week. It is recommended to install a pressure regulator with integrated water trap
and an oiler in the supply line near the tool.
Maintenance
Lubricate daily by adding a few drops of pneumatic oil to the air inlet. Regularly drain condensate from pressure
vessel and water trap. Check oil lever of screwdriver housing monthly. The motor housing should always be
filled approximately half with oil.
Specifications
Max. screw diameter
Max. torque
Speed
Operating pressure
Air consumption
Air inlet thread
Recommended hose size
Weight
Sound power level LP
operator's ear based on DIN 45 635 ff
9 mm / 3/8" i.Ø
at the
A
DS 1610
6.5 mm
10 Nm
-1
1.800 min
6 bar
180 l/min
1/4"
1.3 kg
92 dB
3
Advertisement
