Wolf L Series Installation Manual page 13

Built-in ovens

Hide thumbs Also See for L Series:

L Series Oven Installation

Install the Oven

POSITION THE OVEN

Carefully lift the oven up to the opening. Resting the oven

on the cabinet base platform, slide the oven into the

opening until it is approximately 6" (152) from full insertion.

Make sure the conduit slides through the opening in the

platform as the oven is moved into place.

IMPORTANT NOTE: The conduit must fit into the recessed

area along the right rear edge of the oven. Make sure it is

not trapped between the oven and cabinet wall.

IMPORTANT NOTE: To avoid interference, a 90° door stop

may be required for any appliance or cabinet door installed

next to an L series oven with tubular handle.

Do not block the exhaust vent located at the bottom

of the oven. It must remain clear for proper ventilation.

MOUNT OVEN TO CABINETRY

Once the oven is fully inserted into the opening, locate the

mounting holes on the oven side trim. There are four

mounting holes for a single oven and six for a double

oven. Refer to the illustration below. Use a

drill pilot holes into the cabinet. Using the wood screws

provided, secure the oven to the cabinet.

Failure to install the mounting screws may cause the

oven to tip forward during use.

Location of mounting holes.

wolfappliance.com/specs

" drill bit to

Table of Contents