Table of Contents
Advertisement
10. Front Audio
If the housing has been designed with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector. By the way, please remove
the jumper cap from the Front Audio Connector before you connect the cable. Do not
remove this yellow jumper cap if housing without an audio port on the front panel.
Pin 1
1
2
GND
FP_MIC
+5V
NC
JS1
PHONE_R
KEY
NC
NC
PHONE_L
9 10
11. Support 10/100 Mbps LAN onboard
VIA Apollo Pro 133T chipset includes a fast Ethernet controller on chip. On the strength of
LSI 80225 PHY on board, which is a highly-integrated Platform LAN Connect device, it
provides 10/100M bps Ethernet for office and home use, the Ethernet RJ45 connector is
located on top of USB connectors. The green LED indicates the link mode, it lights when
linking to network and blinking when transferring data. The orange LED indicates the
transfer mode, it will light when transferring data in 100Mbps mode.
AUX-IN
The South Bridge in VIA Apollo 133T chipset integrates a total communication solution including
10/100Mb Fast Ethernet for Office requirement. You can install LAN Driver under Windows
95/98/ME, WindowsNT4 & Windows2000 by following steps.
Manually Adding an Adapter in Windows 95 / 98 / ME / NT4 / 2000:
=====================================
LOCATION OF DRIVER:
(Depend on various Windows version in your system.)
1. From the Control Panel, double-click the "Add Hardware" icon.
2.
Double-click Other Devices or Network Adapters in the list area.
Green/ACT
3.
Double-click a PCI Ethernet Controller.
4.
Click the Driver tab, then click Update Driver.
5.
Click Next at the Update Device Driver Wizard.
Yellow/Speed
6.
Select "Display a list of all the drivers..." and click Next.
7.
Insert the AOpen Bonus CD and click Have Disk.
8.
Enter the appropriate drive for your disc media
(for example: D:\) ,and click OK.
9.
Click OK at the Select Device dialog box.
10. The Update Wizard displays the message that it has found
the driver. Click Next.
11. Click Finish and restart your computer when prompted.
12. Connecting CD / MODEM / AUX
The CD-IN connector is used to connect CD Audio
CD-IN
cable from CDROM or DVD drive to onboard sound.
The MODEM-CN connector is used to connect
Mono In/ Mic Out cable from internal modem card to
onboard sound circuit.
The AUX-IN connector is used to connect MPEG
MODEM-CN
Audio cable from MPEG card to onboard sound.
Connector
CD-IN
MODEM-CN
AUX-IN
13. Installing LAN Driver (Optional)
\Driver\LAN\RTL8100\Windows\
Pin1
Pin2
Pin3
Pin4
Left
GND
GND
Right
Mono In GND
GND Mic Out
Left
GND
GND
Right
Note: If the New Hardware
Found dialog box does not
appear at startup and you
cannot connect to the network,
check the Device Manager list
to see if the new adapter is
present. If it is not, please install
the LAN driver manually.
Advertisement
Table of Contents
