Front Panel Audio Header; Chassis Fan Connectors - ASROCK Z170 Extreme4+ User Manual

USB 3.0 Header
(19-pin USB3_7_8)
(see p.7, No. 7)

Front Panel Audio Header

(9-pin HD_AUDIO1)
(see p.7, No. 25)
1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis
2. If you use an AC'97 audio panel, please install it to the front panel audio header by

Chassis Fan Connectors

(4-pin CHA_FAN1)
(see p.7, No. 26)
(4-pin CHA_FAN2)
(see p.7, No. 13)
(4-pin CHA_FAN3)
(see p.7, No. 8)
26
Vbus
IntA_PA_SSRX-
IntA_PA_SSRX+
GND
IntA_PA_SSTX-
IntA_PA_SSTX+
GND
IntA_PA_D-
IntA_PA_D+
GND
1
MIC2_L
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
GND
FAN_VOLTAGE
CHA_FAN_SPEED
FAN_SPEED_CONTROL
FAN_SPEED_CONTROL
CHA_FAN_SPEED
GND
FAN_VOLTAGE
CHA_FAN_SPEED
Besides six USB 3.0 ports
Vbus Vbus
IntA_PB_SSRX-
on the I/O panel, there
IntA_PB_SSRX+
GND
is one header on this
IntA_PB_SSTX-
IntA_PB_SSTX+
motherboard. Each USB
GND
IntA_PB_D-
3.0 header can support
IntA_PB_D+
Dummy
two ports.
1
his header is for
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
FAN_VOLTAGE
GND
FAN_SPEED_CONTROL