Convenience And Safety Features - CrimeStopper Pro Start LCPRO-3 Operating Instructions Manual

VALET MODE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into Valet Mode.
The Remote Start function WILL NOT operate when in Valet Mode.
1. To Activate Valet Mode Manually: Turn the ignition on and press the Valet button [about 5-6 seconds] until
the LED turns on solid. Repeat the process to exit VALET mode.
2. To Activate Valet Mode with the Remote: Press and hold both the Lock and Unlock Button
together for about 3-4 seconds until 3 chirps are heard (horn must be connected). Repeat this
step to exit via the remote transmitter. Lock / Unlock and AUX features will still operate in VALET Mode
however Remote Start is inhibited.
HOOD OPEN SAFETY (Requires hood pin switch)
Prevents remote starting engine when hood is open. Eliminates risk of injury to someone working under the hood of
the vehicle with a properly working hood pin installed. If Remote Start button is pressed with the hood open, the
parking lights will flash twice and the unit will not attempt a start. The system will abort Remote Start any time the
hood is opened. See Remote Start Diagnostics on page 14.
BRAKE PEDAL RESET:
Prevents starting or turns off a remote started vehicle when this circuit is active. Prevents Unauthorized Driving of
Vehicle. This circuit shuts the system down immediately when brake pedal is pressed. Turn the ignition key to the
"ON" position before the brake pedal is pressed. If Remote Start button is pressed with the brake pressed, the
parking lights will flash once and the unit will not attempt a start. See Remote Start Diagnostics on page 14.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start
and keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security of your
vehicle's factory equipped systems before, during, or after remote start.
OEM REMOTE START: 3 Press Lock = Remote Start thru Data
This mode allows the system to use the OEM Remote Control to Remote Start or Stop with 3 successive Lock
pulses. This feature only works on newer CANBUS vehicles using a Data Module that supports this feature.
With this option you can use both the OEM and Crimestopper remote. The databus module may require custom
programming to enable this feature. Consult with your installer.

CONVENIENCE AND SAFETY FEATURES

11