Maintenance - Panasonic AJ-PCS060G Operating Instructions Manual

P2Store Manager screens (continued)
All erase button
For writing zeros to all sectors of the internal
HDD.
If you are using a battery to power the unit,
switch to an AC adapter before this procedure.
1. Click the [All erase] button
A confirmation dialog is displayed, prompting
you for approval for erasing, after which
another dialog confirms the AC adapter
connection.
2. Click [Yes]
Zeros are written to all sectors.
Maintenance section
Displays the total time that the internal HDD has
been in use.
Drive mount setting button
(only for Windows)
You can select mounting on a drive letter or
specified folder.
When the [Drive mount setting] button is clicked,
the following screen is displayed.
• When mounting on a drive letter:
1. Select [Mount on drive letter].
2. Click the [OK] button.
3. Restart the unit according to the instructions on
the screen.
• When mounting on a specified folder
1. Select [Mount on NTFS folder].
When modifying the drive mount point folder, click
the [Browse] button and specify the mount point.
2. Click the [OK] button.
3. Restart the unit according to the instructions on
the screen.
Note:
1) If you format the HDD using Macintosh
software, always confirm that all data has
been erased after formatting by unplugging
and plugging in the USB 2.0 cable and
checking.
2) Before using [Quick format] and [All erase],
put the unit on a stable surface.
Vibration or impact may damage the unit
during formatting.
Using [Quick format] or [All erase] will
delete all data on the internal HDD.
If data you need is stored on it, back up the
data to separate storage media before
formatting.
E-25
1) – 3)
:
4) – 12)
3) It takes about 45 minutes to write zeros to
all sectors. Always do this with an AC
adapter connected.
4) When [Mount on NTFS folder] is selected,
each partition of the internal HDD of the
unit is sequentially mounted on the
subfolders "pa01" through "pa15." If the
subfolders "pa01" through "pa15" don't
exist under the specified folder, these
subfolders are automatically created.
5) The specified NTFS folder cannot be
mounted for the following cases.
• When the subfolders "pa01" through
"pa15" are not empty.
• When the file system is not NTFS.
6) After executing [Mount on NTFS folder], the
partitions of the internal HDD of the unit are
sometimes not sequentially mounted on the
subfolders "pa01" through "pa15" when the
internal HDD of the unit is formatted or
when a P2 card that is 8 GB or more is
copied to the unit. When the unit and the
computer are going to be connected, we
recommend that you perform mounting.
7) If the number of the partitions is less than
15, when the internal HDD of the unit is
formatted and reconnected after mounting
is performed, a confirmation dialog is
displayed. Follow the instructions on the
screen.
8) When the input folder name does not exist,
a confirmation dialog is displayed. Click
[Yes] after confirming this input folder name.
9) If the subfolders "pa01" through "pa15" are
accessed after mounting when the unit and
the computer are not connected, a
confirmation dialog may be displayed.
10) When disconnecting the unit from the
computer after executing [Mount on NTFS
folder], only one drive letter that was
assigned on the P2 card is displayed.
11) The icon display for subfolders "pa01"
through "pa15" may be different after
executing [Mount on NTFS folder].
However, data accesses will be performed
without problems.
12) When copying the data in subfolders "pa01"
through "pa15" after executing [Mount on
NTFS folder], perform a "copy" rather than
a "move."