Panasonic AJ-PCS060G Operating Instructions Manual page 16

Copying (continued)
Battery level indicator
When using an optional battery pack, you can check the remaining level. You can see how much
power is left by pressing the [
level】 , below.
Copy operations are not possible in the following states.
• Low power error (The [ERROR] LED lights in red and the [E2] in [REMAIN] flashes in red.)
• Low battery pack charge error (detected when copying P2 cards of capacity 16 GB or higher)
(The [ERROR] LED lights in red and the [E2] in [REMAIN] lights in red.)
Once the level reaches 0 (zero), an error is displayed as described in【Battery level】and the
unit goes OFF immediately. Switch to another optional battery pack that is fully charged or use
an optional AC adapter.
With the unit ON, press the [
The display will correspond to【Battery level】 , below.
【Battery level】
: LED lit
Battery pack
level
100
0
The [REMAIN] indicator goes out after about 2 seconds.
Note:
With an AC adapter, in some cases the LED display may not indicate 100. This is not a problem.
E-15
] button and checking the [REMAIN] indicator. See【Battery
] button
, : LED flashing R : red G : green
G G
G G
G G
G G
G
R
R R
REMAIN
G G
G G
G
R R
G
R R