Advertisement
10
Tools Needed:
. *ndard#2 Phillips scnwdriver
. Tape-6.ppedp~ kniti
filler plugs opposite the hinges.
2
With the door completely open,
remove the bottom screw from
each hinge on the dryer face.
3
Insert these screws about htiway
into the TOP holes, for each hinge,
on the opposite side. (Where you
removed the filler plugs.) Apply
started in untapped holes.
4
hinge on the d~er face ha~way.
5
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it
UP and OUT.
6
on the opposite side of the open-
ing by moving the door IN and
DOWN until the top hinge and
the bottom hinge are resting on
the top screws inserted in step 3.
Remove the remaining screws
7
from tie side of the opening
from which the door was
removed. With these screws
secure each hinge at the bottom.
Tighten the two top screws of -
8
each hinge.
Reinsert the plastic plugs on
9
the side from which the door
was removed.
Advertisement
