Attach Vacuum Hose And Tools; Attach Handle To Vacuum - Bissell powergroom rewind User Manual

A
ssembly
you need: phillips head screwdriver.

attach handle to vacuum

1. Locate the vacuum handle and remove
the screw packet taped to the base of
the handle.
2. Stand the vacuum upright and slide the
base of the handle firmly into the grooves
at the top of the vacuum body.
3. Insert the screws provided from the screw
packet into the existing holes. Tighten
securely with a screwdriver.

attach vacuum hose and tools

1. Line up tabs on the base of the Twist
'n Snap™ hose with the corresponding
notches on the hose collar. Turn the
hose to the right to lock into place.
2. Grasp the Hose Wand and slide the
end of the hose wand into the hose
wand base. Snap the hose into the
upper hose clip on handle.
3. Slide the extension wand and crevice
tool together into storage clip.
4. Snap the combination tool into the
storage clip.
5a. For models 5957 & 6355, the TurboBrush
Tool bracket slides into the front of the
handle. Attach the bracket by aligning the
pegs with the holes on the handle, pulling
down until it locks into place.
5b. Place the TurboBrush Tool in the
bracket by aligning the bottom of
bracket with the opening of the brush
roll and snap the TurboBrush Tool
into place.
WaRning:
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies
and children.
w w w . b i s s e l l . c o m
2.
1.
4.
5a.
3.
3.
5b.
5