Checking Rotating Floor Brush/Drive Belt; Replace Drive Belt - Bissell powergroom rewind User Manual

M
aintenance and care
checking rotating floor brush
and drive belt
check your vacuum's rotating floor
brush and drive belt regularly for
wear or damage.
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Place handle in low position and turn
vacuum over so bottom side is facing up.
3. Using a screwdriver, remove the screws
and lift brush cover off.
4. Grasp rotating floor brush at both
ends and lift.
5. Clean strings, hair and other debris
from rotating floor brush, motor pulley
and drive belt areas.
6. Check drive belt for wear, cuts or
stressed areas.
7. Check air passageway for obstructions.
Remove debris from this area.

Replace drive belt

1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. With rotating brush removed (steps 1-4
of ckecking rotating floor brush and
drive belt), grasp old drive belt and
remove from motor pulley. Discard old
drive belt.
3. Place new drive belt over motor pulley
and stretch other end over rotating floor
brush in the space between the bristles.
4. Place ends of rotating floor brush down
into slots.
5. Turn rotating floor brush by hand in the
direction of the motor pulley. If properly
installed, drive belt will center itself on
rotating brush.
6. Reposition brush cover and fasten
screws back into place.
10
w w w . b i s s e l l . c o m
WaRning:
To reduce the risk of injury from
moving parts, turn the power
switch OFF and disconnect plug
from electrical outlet.
3.
4.
Motor
Pulley
7.
3 & 4.
Motor
Pulley
6.
Brush Cover
Air
Passageway
Brush Cover