Canon imageRUNNER ADVANCE 8105 Getting Started page 83

2
Specify the settings for SNMP v . 3 .
[On] for <Use SNMP v. 3>: Specify the user and context according to the following procedures.
An SNMP v. 3 user with the following settings is registered by default. Delete or change these settings as necessary.
- User: initial
- MIB Access Permis.: Read/Write
- Security Settings: Auth. Yes/Encry. Yes
- Authent. Algorithm: MD5
- Authent. Password: initial
- Encryption Password: initial
● If you want to add an SNMP v . 3 user:
☐ Press [User Settings] → [Register] → specify the user name, MIB permissions, and security settings.
If you select [Auth. Yes/Encry. Yes] from the Security Settings drop-down list, select the authentication algorithm → enter the
passwords for authentication and encryption. If you select [Auth. Yes/Encry. No] from the Security Settings drop-down list, select the
authentication algorithm → enter the password for authentication.
● If you want to confirm or change the SNMP v . 3 user settings:
☐ Press [User Settings] to select the user whose settings you want to confirm or change → press [Details/Edit].
Confirm the displayed information → change the settings if necessary.
● If you want to delete an SNMP v . 3 user:
☐ Press [User Settings] to select the user whose settings you want to delete → press [Delete].
● If you want to change the status of an SNMP v . 3 user:
☐ Press [User Settings] → select the user whose status you want to change → press [User On/Off ].
Communication Environment Setup
3
3-11