How To Use; Operating The Vacuum - Vax VX37 User Manual

Operating the Vacuum

WARNING: For Wood Floors, Soft Floor Surfaces (Vinyl, Asphalt Tile, etc.) and Polished Floor Finishes: Use low speed
on hard floor surfaces. Use floor and floor finish manufacturer's recommended methods of cleaning. The brushroll may
also scuff very soft finishes. Always test a small area to determine if surface is suitable for the cleaner.
1. Make sure the disposable inner HEPA dust bag is in place. Do not operate the vacuum without a disposable inner HEPA dust
bag. Plug the power cord into an electrical outlet and press the ON/OFF switch on the back of the vacuum when ready to
operate. Press the button once to turn the unit on high, press a second time for low speed, and a third time to turn the unit off.
2. Up-Position Lock: Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the
full upright position to engage lock. NOTE: Do not operate the vacuum while in the upright and locked position. Do not let the
vacuum run while in any one stationary position for any period of time.
Keep the vacuum moving while in operation.
3. Cord Release: To remove cord, twist cord release 1/2 turn.
Slide cord off cord release.
4. Easy Power Cord Storage: Turn cord release to the up position,
wrap power cord around cord release and lower cord bracket
located below the carry handle.
5. Carry Handle: The carry handle is located
on back of the vacuum for easy lifting
and carrying.
2
vax.com.au
vax.co.nz
1
5

How To Use

3
4
6