Error Mode - LG TD-C7014 series Service Manual

10 TROUBLESHOOTING

Error Mode

: LED displays "
Button must be pressed for re-operation. (See the 22page)
Case 1. When black out or irregular current occurs.
- After removing ELB Connector, operate full time 1Cycle.
Case 2. EHE (ELE) message expresses continuously because of aging items.
- Change the old items.
: The resistance of thermistor not normally out put.
Case 1. The Circuit of thermistor is troubled.
- Repair the Circuit of thermistor.
Case 2. Thermistor is troubled.
- Replace the Thermistor.
Case 3. The Controller is troubled.
- Repair or replace the Controller.
Check Red 4P Housing
Check Test Mode
Check Thermistor resistence
Replace PCB
Lamp Broken
Connector malfunction
Check Heater Power
Thermostat trip
Check thermistor open/short
Fan
" in case of the door open. The door must be closed and start
Power button press
YES
NO
Lamp on?
NO
Power-Off
Power-On
LED-SEG ON
YES
YES
drum not
Rotating
Start button Lock:
NO
No buzzer
(Rotating)
Door Open?
Door is not closed
(" ")display
NO
Drum Belt broken
Check Filter sign
glitters
Properly
Drying?
Water container
sign
YES
Over clothes Load
Motor malfunction
2 0
NO
Plugged in
Power button
Lock:No buzzer
Circuit breaker
trip
Low temperature
Replace PCB
Replace Belt
Clean Filter
and Condenser
Empty Water
Container