Maintenance; Specifications; Cleaning The Cabinet - Sharp HT-SB32D Operation Manual

Troubleshooting chart
■ Condensation
Sudden temperature changes, storage or operation
in an extremely humid environment may cause
condensation inside the cabinet or on the transmitter
on the remote control.
Condensation can cause the sound bar to malfunc-
tion. If this happens, leave the power on until normal
operation is possible (about 1 hour). Wipe off any
condensation on the transmitter with a soft cloth
before operating the sound bar.
■ Factory reset, clearing all setting
Make sure to disconnect all audio input cables
attached to the sound bar before performing the
factory reset.
1. Press ON/STANDBY button to enter the power
standby mode.
2. While pressing down the PAIRING button,
press the ON/STANDBY button.
3. Press the ON/STANDBY button again.
(PAIRING indicator will turn BLUE.)
Caution:
This operation will erase all data stored in memory.
■ If problem occurs during operation
When this product is subject to strong external inter-
ference (mechanical shock, excessive static electric-
ity, abnormal supply voltage due to lightning, etc.) or if
it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1
Set the sound bar to the standby mode
and turn the power on again.
2
If the sound bar is not restored in the
previous operation, unplug and plug in the
sound bar, and then turn the power on.

Maintenance

■ Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth.
Cautions:
Do not use chemicals for cleaning (gasoline, paint
●
thinner, etc.). It may damage the cabinet finish.
Do not apply oil to the inside of each component.
●
It may cause malfunctions.
SOUND BAR HOME THEATER SYSTEM HT-SB32D

Specifications

As part of our policy of continuous improve-
ment, SHARP reserves the right to make
design and specification changes for product
improvement without prior notice. The perform-
ance specification figures indicated are nominal
values of production unit. There may be some
deviations from these values in individual unit.
■ General
Power source DC IN 19V
Power
consumption
Maximum
output power
Speaker
Input
terminals
Bluetooth
Frequency
Band
Compatible
Bluetooth
Profile
Dimensions
Weight
E-21
3.42A: AC/DC
adaptor
(AC 100 - 240V ~ 50/60Hz)
10 W
RMS: Total 60 Watts
30 Watts per channel into
6 ohms at 1 kHz, 10% total
harmonic distortion
FTC: Minimum 23 watts
per channel into 6 ohms at
100 Hz to
20 kHz, 1% total harmonic
distortion
2-way Speaker System
2-1/4" (5.7cm) Woofer
1" (2.5cm) Soft Dome
Analog input (AUDIO IN):
Stereo mini jack Ø 3.5mm
500mV / 47kΩ
Optical digital input
(OPTICAL): Square type x 1
2.400GHz - 2.480GHz
A2DP (Advanced Audio
Distribution Profile), AVRCP
(Audio/Video Remote Control
Profile)
Bluetooth 2.1 +EDR
Width: 37" (940mm)
Height: 2-7/8" (73mm)
Depth: 3-1/4" (83mm)
5.1 lbs. (2.3 kg)